perkins edi v3.0 1300 diagnostic software free download

Two types of faults are found by the engine control module (ECM)Īnd retained in its memory, they are active faults and inactiveįaults. Some Perkins engine are fitted with a self-test system, whichĬan be used to check for active and inactive faults. Set the start switch to the ‘ ON ’ position, but do not start the engine. H1 = ECM: FAULT-WARNING LIGHTS H2 = ECM: FAULT-WARNING LIGHTS PD = ECM: SELF TEST INPUT/DIAGNOSTIC START PUSH BUTTON PAE = ECM: MANUAL POWER PUSH BUTTON How to check for faults codes? (Operation 17-1) The self-test system usually consists of a button, an orange lamp and a red lamp. (Please refer to the Workshop Manual TPD 1353 E) View of Zordan ’s dashboard: In order to understand the meaning of the lights & buttons installed by Zordan on the dashboard, you need to refer to the file « CODE INDEX ZORDAN ». A special diagnostic tool is necessary to operate the full range of diagnostic tests on the engine management system. The self-test system should be fitted to every application, it can be used to find faults in the engine management system. This could be because it was repaired, or it is an intermittent fault. An inactive fault is one that was an active fault at some time, but is not present now. When an active fault has been repaired, it becomes an inactive fault after 15 seconds. An active fault is one that was found by the engine control module and has not been repaired. Active faults and inactive faults are shown on the diagnostic tool as “ ACTIVE CODES” and “INACTIVE CODES”.

Two types of faults are found by the engine control module (ECM) and retained in its memory, they are active faults and inactive faults. It will also check all outputs for open circuit. PERKINS 1300 SERIES (Diagnostic w/o DIAG TOOL) Some Perkins engine are fitted with a self-test system, which can be used to check for active and inactive faults.

Perkins edi v3.0 1300 diagnostic software free download